forum.skoda-club.ru

Hi to all fans of Skoda. Sorry for writing in english, but my russian is very bad. I have a question and would really appreciate if someonе can help me.

I have my 3rd Skoda - this time it is Octavia vRS FL - 2.0 TDI.
I have an idea of making a full change of the sound in the car. Unfortunatelly i have a problem with fitting the high tone speaker. I have Hertz HSK 163 component system, and the high tone speaker is 25mm Hertz HT25. I removed the old tweeter, and saw that the hole for fitting is smaller. After one hour of carefull working - i made the hole enough big to fit the new speaker. Here is my ptoblem. The Hertz HT25 tweeter is a little bit deeper in front - and the decorative cover in front of the speaker - but the speaker is making it impossible. It is about 5 mm out - and does not allow to fit the decorative grid cover. I think of cutting a hole in the cover - and to put the speaker through the hole - this will allow to see the beautiful Hertz emblem and cover - but am afraid because i dont know how it looks like.

Here is a photo od the tweeter :



Does anyone have the same problem, and have found a solution? Please help me to solve this problem.

Thank you in advance

BTW you have made one amazing forum and Skoda comunity....thank you for that

Hello.You are welcome foreign guest.My second language badly too.I will write you personal message.
Не хочу позориться своими языковыми познаниями

ну не писал бы ничего ))

Напишите автору кто-нить пограмотнее, что задолбается доделывать штатное место для твитера+ резко будет чрезмерно ибо твитеры совсем близко стоят

Eu-Jinn писал(а):ну не писал бы ничего ))

Напишите автору кто-нить пограмотнее, что задолбается доделывать штатное место для твитера+ резко будет чрезмерно ибо твитеры совсем близко стоят

Совсем плохо написал? Это на тот случай чтобы Л.С. проверил

Hi friends, thank you for the answers. Here are some photos for my work.







The problem is with the decorative cover on photo Nr.3 - I can not put it on place because the speaker is very high, and it touches the cover. I need an idea how to fix this. I think of cutting the decorative cover - and put the speaker in it.
Please help

Надо монтировать не с лицевой, а с тыльной стороны. Приклеить с помощью клея или герметика

I have had the same problem with Space 1. You need to remove the high tone`s grill. Completely. I advise you to sell HT25 and buy more bigger tweeters to install in side racks.